---

name: starlink version: 1.0.0 description: Control Starlink dish via local gRPC API. Get status, list WiFi clients, run speed tests, stow/unstow dish, reboot, and get GPS location. Use when the user asks about Starlink, internet status, connected devices, or satellite connectivity. homepage: https://github.com/danfedick/starlink-cli metadata: {"clawdbot":{"emoji":"📡","requires":{"bins":["starlink"]},"install":[{"id":"cargo","kind":"cargo","git":"https://github.com/danfedick/starlink-cli","bins":["starlink"],"label":"Install starlink-cli (cargo)"}]}}

Starlink CLI

Control your Starlink dish from the command line via its local gRPC API at 192.168.100.1:9200.

Installation

cargo install --git https://github.com/danfedick/starlink-cli

Requires Rust and protoc (Protocol Buffers compiler).

Commands

Status

Get dish state, uptime, SNR, latency, throughput, obstructions:

starlink status
starlink status --json

WiFi Clients

List devices connected to the Starlink router:

starlink clients
starlink clients --json

Output includes: name, MAC, IP, signal strength, interface (2.4GHz/5GHz/ETH), connection time.

Speed Test

Run a speed test through the dish:

starlink speedtest
starlink speedtest --json

Returns download/upload Mbps and latency.

Stow/Unstow

Stow dish flat for transport or storage:

starlink stow           # stow
starlink stow --unstow  # unstow and resume

Reboot

Reboot the dish:

starlink reboot

Location

Get GPS coordinates (must be enabled in Starlink app → Settings → Advanced → Debug Data → "allow access on local network"):

starlink location
starlink location --json

Output Formats

• Default: Human-readable colored output
• --json: JSON for scripting/parsing

Example JSON parsing:

starlink status --json | jq '.latency_ms'
starlink clients --json | jq '.[] | .name'

Requirements

• Connected to Starlink network
• Dish reachable at 192.168.100.1:9200
• For location: enable in Starlink app first

Troubleshooting

"Failed to connect to Starlink dish"

• Verify you're on the Starlink WiFi or wired to the router
• Check: ping 192.168.100.1
• If using bypass mode with your own router, ensure 192.168.100.1 is still routable

Location returns empty

• Enable in Starlink app: Settings → Advanced → Debug Data → "allow access on local network"

Limitations

• Device pause/unpause is NOT available (cloud-only feature via Starlink app)
• Only works on local network, not remotely

Source

https://github.com/danfedick/starlink-cli